Easy Maintanence and Care Instructions~
Caring for your Ceramic Christmas Tree is easy! 

Cleaning:  Use a feather duster for light cleaning.  Use warm water and a soft cloth to keep surfaces clean and free from dust or dirt.  Avoid excessive moisture, and do not immerse the base with light fixture in water.  If your tree gets wet while cleaning and the glue softens, the lights may become loose.  Simply leave lights in place to reset the glue, or apply a small amount of Elmer's Glue to the light stem and rest into the hole.

Loose lights on tree:  If the lights in your tree get loose just apply a little Elmer's Glue to the stem of the light/near the hole.  Elmer's will set in about a half hour and dries clear.  Never use any toxic or permanent glue since the tree will warm slightly with the light fixture on, and you also do not want to harm the finish on your tree.

Light Bulb inside tree (on base) will not light:  Do the following checks --

1. DO NOT REMOVE OR DISASSEMBLE THE LIGHT FIXTURE.  Your tree has very simply wiring and it is almost impossible for anything to go wrong with the light socket itself.  Disassembling the light fixture on the base is done AT YOUR OWN RISK.  If you have tried all of the remedies that follow and still have trouble, please contact us for further assistance.
   
2. Check the dial switch located on the cord to make sure it is on the "on" position.
    
3. UNPLUG your tree from the outlet.  Check the light bulb to see if it needs to be replaced (you will be able to see that the wires inside the bulb are broken or if you shake the bulb, it will rattle).  Replacements can be found on our parts page here or you can find the 7 watt night-light type bulb at your local hardware store or Home Depot, Lowes, etc. if you have one of our 11 inch trees.
   
4. UNPLUG your tree from the outlet.  Check the cord to make sure there are no breaks, frays, or cuts.  If the cord needs to be replaced, please contact us to make arrangements.